This is a custom Paughco frame which marries a 45" Flathead motor to a Big Twin 4 speed. Gary wanted a belt guard on the bike we're building for him, but didn't want to cover it completely. First I tried a 45 primary cover and it was too short, so moved on to this Panhead primary cover. No worries, this stuff I'm cutting up is repop. Sort of wish I had not cut the diamond open but I need to build floor board mounts off the rear motor mount and through the primary. The clutch arm needed to be extended under the oil bag so I duplicated the rod hole at the end and now I just need to trim the old hole off.
No comments:
Post a Comment